SharkRF openSPOT2 - REF;XRF Connector; URCALL;Your Call Method; DTMF Method

REF/XRFconnector
YoucanusethisconnectortoconnecttoanetworkwhichsupportstheDplusprotocollikeREForXRF.
TheeasiestwayistousetheQuicksetuptoconnecttothesenetworks.
Ifyouwanttouseareflector,settheURCALLonyourradiotoCQCQCQ,andthelocalmoduletoDinthe
openSPOT2.Ifyouwanttouseagateway,settheURCALLtothegateway'scallsignandremotemodule.
RemotemoduleshouldbethelastcharacteroftheURCALL.Inthiscase,setthelocalmoduletoaspace
characterintheopenSPOT2.
Notethatifyouareconnectingtoarepeater,youhavetosettheReflector/gatewayIDconnectorsettingtothe
callsignoftherepeater.
REFandXRFserversneedavalidD-STARregistration.Youcancheckyourcallsign'sregistrationbyclickingon
theCheckD-STARregistrationbutton.MakesureyouhaveregisteredyourlocalmoduleontheD-STARgateway
registrationsystem.Ifyouhavearegistration,youhaveprobablyregisteredthe"space"localmodule,inthiscase
setyouropenSPOT2'slocalmoduletoaspace(empty)character.
TryremotemoduleEonanyreflectorfortheREF/XRFechoservice(maynotenabledonsomeservers).
Switchingreflectors/gatewaysusingyourradio
URCALL/yourcallmethod
Youcanswitchreflectorsusingyourradiobystartingashortcalltotheirnamesasthedestinationcallsign
(URCALL),likeREF001A,orXRF001A.SetthedesiredremotemoduleasthelastcharacteroftheURCALL.You
canswitchtogatewaysthesameway.YoucanalsoswitchtoDCS/XLXserversbythismethod.Switchingto
DCS/XLXserversthiswaychangestheopenSPOT2'sactiveconnectortotheDCS/XLXconnector.
DTMFmethod
HerearesomeexampleDTMFcommandsequences:
SwitchingtoREFservers:
REF/XRF
77