SharkRF openSPOT2 - POCSAG Settings

ThemodemwillonlyprocessP25callswithamatchingNetworkAccessCode(NAC).NotethattheopenSPOT2
requirestheNACindecimalformat(example:ifyouhavetheNAC0x293inyourradiothenyouhavetoenter
659intheopenSPOT2).
IfthesourcecallsignofacrossmodecallhasnoassociatedDMR/P25/CCS7ID,anditcan'tbeparsedintoa
number,thentheDefaultcrossmodesourceP25IDwillbeusedfortheoutgoingP25call.Ifyouaretheonly
personusingtheopenSPOT2,setthistoyourDMR/P25/CCS7ID,andthenyoudon'tneedtochangethe
callsignofyourradiotoyourDMR/P25/CCS7ID.
IfAdvancedmodeisenabled,thefollowingsettingsshowup:
IfacallisreceivedbythemodemtotheEchoID,thentheopenSPOT2'sbuilt-inlocalechoservicegets
activated.Itwillrecordthecallandplaysitbackafterthecallisfinished.Bothprivateandgroupcallsare
answeredwithaprivateechocallreply.
IftheAllowonlyIDsascrossmodecallsignssettingisenabled,andthesourcecallsignofacrossmodecallhas
noassociatedIDinthedatabase,andalsoitcan'tbeparsedintoaDMR/P25/CCS7ID,thenthecallwillbe
ignored.
POCSAGsettings
ThissectionisonlyavailableifAdvancedmodeisenabled.
IfthemodemistransmittingPOCSAGmessagesthenitwillswitchtothePOCSAGfrequency.TheTXdelayin
othermodemmodessettingspecifieshowmanysecondstheopenSPOT2shouldwaitafterthelastcallhasbeen
finishedtoswitchtoPOCSAGmodeandstarttransmittingthequeuedmessages.
Settingspage
53