SharkRF openSPOT2 - DAPNET Connector

DAPNETconnector
YoucanusethisconnectortoconnecttoanetworkwhichsupportstheDAPNETprotocol.
TheeasiestwayistousetheQuicksetuptoconnecttotheseservers.
ThisconnectorsupportsthePOCSAGmodemprotocolwhichistheprotocolusedbypagers.Youcanfindmore
informationaboutPOCSAGandDAPNEThere.
TheopenSPOT2actsasatransmitteronDAPNET,somakesureyouuseyourDAPNETtransmitterloginandauth
keyforconnectingtheopenSPOT2.ThesearenotthesameasyourDAPNETuseraccount.Aseparatetransmitter
registrationisneeded.Seethispageformoreinformation.
ThisconnectorcanstayactiveinthebackgroundifStayconnectedinbackgroundischecked,whichmeansyou
canusetheopenSPOT2thesamewayasbeforewithotheractiveconnector,butitwillfunctionalsoasa
personalDAPNET/POCSAGtransmitter.TheopenSPOT2willautomaticallybroadcastDAPNET/POCSAGmessages
whenthere'snocallcomingfromthenetworkormodemforPOCSAGTXdelayseconds(thiscanbesetonthe
Settingspage,POCSAGsettingssection),soongoingcallswon'tbeinterruptedbyPOCSAGmessaging.Ifthe
DAPNETconnectorisrunninginthebackgroundthenyoucanseeit'sconnectionstatusontheStatuspage.
DAPNET
85