SharkRF openSPOT2 - DCS;XLX Connector; URCALL;Your Call Method; DTMF Method

DCS/XLXconnector
YoucanusethisconnectortoconnecttoanetworkwhichsupportstheDCSprotocollikeDCSorXLX.
TheeasiestwayistousetheQuicksetuptoconnecttothesenetworks.
DCSandXLXserversusuallydonotneedavalidD-STARregistration,butyoucancheckyourcallsign's
registrationbyclickingontheCheckD-STARregistrationbutton.
IfyouwanttotalkonaDCSorXLXreflector,settheURCALLonyourradiotoCQCQCQ,andthelocalmoduleto
DintheopenSPOT2.MakesureyouhavenotenteredanyspacecharactersinyourradiobeforeorafterCQCQCQ
intheURCALL.
Switchingreflectors/gatewaysusingyourradio
URCALL/yourcallmethod
Youcanswitchreflectorsusingyourradiobystartingashortcalltotheirnamesasthedestinationcallsign
(URCALL),likeDCS001A,orXLX001A.SetthedesiredremotemoduleasthelastcharacteroftheURCALL.You
canswitchtogatewaysthesameway.YoucanalsoswitchtoREF/XRXserversbythismethod.Switchingto
REF/XRFserversorgatewaysthiswaychangestheopenSPOT2'sactiveconnectortotheREF/XRFconnector.
DTMFmethod
HerearesomeexampleDTMFcommandsequences:
SwitchingtoREFservers:
*1Cor *01Cor *001CwillchangetheactiveconnectortotheREF/XRFconnectorandconnectstoREF001
moduleC.
SwitchingtoXRFservers:
B8Bor B08Bor B008BwillchangetheactiveconnectortotheREF/XRFconnectorandconnectstoXRF008
moduleB.
SwitchingtoXLXservers:
DCS/XLX
75