SharkRF openSPOT2 - C4 FM;Fusion Settings

IftheTransmitRXconfirmationcheckboxischecked,theopenSPOT2willtransmitashortcallconfirmationafter
thePTTisreleasedontheD-STARradio.
IftheAutomuteDTMFcommandscheckboxischeckedandacallisongoingfromthemodem,andaDTMF
sequenceisbeingentered,thenthecalltothenetworkwillbeautomaticallyended,sootherswon'tbeannoyed
byhearingyourDTMFtonesonthesamereflector/gateway.
C4FM/Fusionsettings
ThissectionisonlyavailableifAdvancedmodeisenabled.
Allowdatacallstonetwork:ifenabled,datacallswillbeforwardedfromthemodemtothenetwork.This
isnotrequiredfornormaloperation.
IgnoreWires-Xbuttoncommands:Wires-Xbuttoncommandsreceivedbythemodemwillbeignoredin
casethissettingsisenabled.
Don'tsendautomaticWires-Xconnectmessages:theopenSPOT2automaticallysendsWires-Xconnect
messagesincaseitconnectsordisconnectsto/fromaserver.Theseautomaticmessagescanbedisabled
withthissetting.
HideprofilesinWires-X"all"reply:ifthissettingisenabled,configurationprofileswon'tbelistedonthe
firstpageforaWires-X"all"serversearch.
AutomuteDTMFcommands:ifacallisongoingfromthemodem,andaDTMFsequenceisbeingentered,
andthefirstcharacterisaSpecialcommand/crossmodeprivatecallorCrossmodegroupcallDTMF
code,theoutgoingcalltothenetworkwillbeautomaticallyended,sootherswon'tbeannoyedbyhearing
yourDTMFtonesonthesamereflector/talkgroup.
Specialcommand/crossmodeprivatecallDTMFcode:thiscodeisusedasthefirstcharacterforenteringa
controlDTMFcode,orstartingaprivatecallincrossmodemmodes.Seemoreinfoateachconnector's
Settingspage
51