SharkRF openSPOT2 - Modem Page; Frequency; CW ID

Modempage
Youcanchangethemodemsettingsonthispage.
Ifyouchangethemodemmode,RXorTXfrequencyonthispage,thevalueswillbecopiedtothecurrently
activeconnector'ssettings.IfAdvancedmodeisturnedoff,bothRXandTXfrequencieswillbeautomaticallyset
tothesamevalue(theseparateRXandTXfrequencyfieldswillbehidden).
IftheIdlemodemmodeisactivatedthentheopenSPOT2'smodemwon'ttransmitandwillignoreallreceived
transmissions.
IncaseyouhavehalfdeviationenabledinyourC4FM/Fusionradio(somemodelsdon'thavethissettingandhave
halfdeviationmodeenabledbydefault),usetheC4FMHalfDeviationmodemmode.
Frequency
TheModemreceivefrequencyoffsetsettingcanbeusedtocorrectthefrequencydifference(RXoffset)between
theopenSPOT2andtheusedtransmitter.ThissettingisonlyavailableifAdvancedmodeisenabled.
SettinganRXoffsetmaybeneededincaseothersreportthattransmissionscomingfromyourtransceiverhave
voicequalityissues.ThisshouldrarelyhappenastheopenSPOT2hasabuilt-in,factorycalibrated,extreme
accurateclockreference.YoucanalsousetheAutoCalspecialconnectortofindouttherequiredRXoffset
value,oryoucanusetheopenSPOT2'sbuilt-inlocalechoservicetofindouttheRXoffsetvalueyourselfby
listeningbackyourrecordedvoice.
CWID
YoucansetaCWIDwhichtheopenSPOT2willtransmitatthespecifiedintervalwiththespecifiedspeed.You
canuseletters,numbers,slash(/)andspacecharactersintheID.
Modempage
44