SharkRF openSPOT2 - Other Modem Settings

NotethattheopenSPOT2transmitsanunmodulatedcarrierwave,soyou'llonlybeabletohearitusingaradio
whichiscapableofCW/SSBdemodulation.
BeforetheopenSPOT2startstotransmittheCWID,itwaitsatleastTXdelaysecondsafterthelastreceivedcall.
Anincomingcall(bothfromaradioorfromthenetwork)willinterrupttheCWIDtransmission,soenablingthe
CWIDdoesnotinterferewiththeopenSPOT2'snormaloperation.
Othermodemsettings
IfAdvancedmodeisenabled,youcantweakvariousothermodemparametersatthebottomofthemodem
page.
TheCallhangtimesettingspecifieshowmanymillisecondstheopenSPOT2willwaitafterthelastvalidframe
hasbeenreceivedtoconsideracallhasbeenfinishedwithatimeout.
IftheBCLOlevel(BCLO-BusyChannelLockOut)settingisnot0,thentheopenSPOT2'smodemwillonlystart
atransmissionifit'sRSSImeterdoesnotmeasureasignalstrengthabovethespecifiedBCLOvalueindBm.
TheIgnoreRXafterTXsettingspecifiesatimeforwhichallreceivedframesbythemodemwillbeignoredafter
thelastTXhasended.ThisisusefulifyouwanttousetheopenSPOT2tolinkarepeatertotheinternetthrough
RFandtherepeaterhasalengthyinternalbufferanditisstilltransmittingevenaftertheopenSPOT2has
finishedtransmitting(whichmeanstheopenSPOT2willstartreceivingit'sownstreamagain).
Modempage
45