SharkRF openSPOT2 - Page 46

Themodem'sSensitivitylevelcanbechangedin6levels.Notethatincreasingsensitivitydecreasesthelinearity
ofthefilters,whichmayresultinincorrectlydemodulatedbits(whichmeansincreasedBER).Bydefault,
sensitivityislow(levelsetto5or6)formodemmodesusing4FSK.
Thesensitivityofthemodem'sfiltercanbechangedwiththeFiltergainsetting.Notethatincreasingsensitivity
decreasesthelinearityofthefilters,whichmayresultinincorrectlydemodulatedbits(whichmeansincreased
BER).Bydefault,filtergainissetto8.
Themodem'sAGC(AutoGainControl)isconfiguredbysoftwareforoptimalvaluesforlowBERin4FSK
demodulationmodes.However,youcanturnautomaticAGConwiththeAutoAGCsetting,butitis
recommendedtokeepthischeckboxoffsotheopenSPOT2'sAGCcanworkonit'sown.
WhentheAGCisturnedon,youcansettheAGClow/highthresholdvalues.Thesevalueswillbeconsideredas
lowandhighthresholdsfortheAutoAGCcircuitryinthemodem.
TheExternalVCOcheckboxshouldbecheckedwhenanexternalVCOisappliedtotheopenSPOT2.Currently
there'snoexternalVCOusedbytheopenSPOT2.NotethatapplyinganexternalVCOisconsideredasanafter-
marketmodificationandvoidsthewarrantyoftheopenSPOT2.
YoucanalsoresetallmodemsettingsbacktodefaultsbyclickingontheResetmodemconfigbacktodefaults
button.
Allofthesettingsabovearestoredindependentlyforeachmodemmodeinthecurrentprofile.
Modempage
46