SharkRF openSPOT2 - NXDNReflector Connector; Talkgroup Handling; Switching NXDNReflector Servers Using Your Radio; Cross Mode Usage

NXDNReflectorconnector
YoucanusethisconnectortoconnecttoanetworkwhichsupportstheNXDNReflectorprotocol,like
NXDNReflectorservers.
TheeasiestwayistousetheQuicksetuptoconnecttothesenetworks.
Talkgrouphandling
NXDNReflectorservershandleonlyonetalkgroup.Youcanfindeachserver'stalkgroupIDintheserverlist,orif
youenableAdvancedmode,thenthetalkgroupIDsettingwillbeshown.
IfyouuseNXDNmodemmode,thenmakesureyousendyourcallsasagroupcalltothetalkgroupID,
otherwisetheserverwillignoreyourcalls.AlsomakesureyouhavethetalkgroupIDinyourSelCalllist(if
SelCallisenabled),otherwiseyouwon'thearincomingcallsonyourradio.
Ifyouusecrossmodemmodes,thensendyourcallsasagroupcalltothetalkgroupID,otherwisetheserver
willignoreyourcalls.
IfyouuseaDMRradio,thenmakesurethetalkgroupIDissetastheTXcontactforthecurrentchannelin
yourradio,orthetalkgroupIDisinanRXgrouplistwhichisassignedtothecurrentchannelofyourradio,
otherwiseyouwon'thearincomingcallsfromtheserver.
YoucanalsosettheDefaultcrossmodedestinationIDtothetalkgroupIDandenableAlwaysusethisID
incrossmode.ThesesettingsareavailableontheSettingspage,NXDNsettingssection.Thiswayyourcross
modecallswillbealwayssenttothecorrecttalkgroupID.
SwitchingNXDNReflectorserversusingyourradio
YoucanswitchNXDNReflectorserverswithyourradiobycallingthedesiredserver'sIDwithaprivatecall.
Crossmodeusage
TheNXDNReflectorconnectorisanNXDNconnector,butitsupportsDMRandC4FMcrossmodemmodes.
YoucanswitchNXDNReflectorserverswithyourDMRradiobycallingthedesiredserver'sIDwithaprivatecall.
YoucanswitchNXDNReflectorserverswithyourC4FMradiobyenteringtheSpecialcommand/crossmode
privatecallDTMFcodeDTMFcode(bydefaultit's*)followedbythedesiredserver'sID(5numbers).
YoucanalsousetheWires-XbuttonmenuofyourC4FMradiotoselect/searchforservers.
NXDNReflector
81