SharkRF openSPOT2 - DMR Settings; D-STAR Settings

DMRsettings
ThemodemwillonlyprocessDMRcallswithamatchingColorcode.
IfthesourcecallsignofacrossmodecallhasnoassociatedDMRID,anditcan'tbeparsedintoanumber,then
theDefaultcrossmodesourceDMRIDwillbeusedfortheoutgoingDMRcall.Ifyouaretheonlypersonusing
theopenSPOT2,setthistoyourDMRID,andthenyoudon'tneedtochangethecallsignofyourradiotoyour
DMRID.
IfAdvancedmodeisenabled,thefollowingsettingsshowup:
IfacallisreceivedbythemodemtotheEchoID,thentheopenSPOT2'sbuilt-inlocalechoservicegets
activated.Itwillrecordthecallandplaysitbackafterthecallisfinished.Bothprivateandgroupcallsare
answeredwithaprivateechocallreply.
IftheAllowonlyIDsascrossmodecallsignssettingisenabled,andthesourcecallsignofacrossmodecallhas
noassociatedIDinthedatabase,andalsoitcan'tbeparsedintoaDMRID,thenthecallwillbeignored.
IftheForcesourceIDfrommodemissettootherthan0,thesourceDMRIDofallvoicecallsreceivedbythe
modemwillbereplacedwiththisID.
IftheSendnoin-banddatatonetworksettingisenabled,thenin-banddatacomingfromthemodem(likethe
talkeraliasorin-bandGPSpositioninformation)won'tbesenttothenetwork.
IftheForcetalkeraliastoDMRnetworkisset,thenthistalkeraliaswillbesentforallcallscomingfromthe
modem.
IftheSendnoin-banddatatomodemsettingisenabled,thentheopenSPOT2willremoveallin-banddata
fromcallscomingfromthenetwork.Bydefaultthissettingisenabled.Ifyouhavearadiowhichsupportstalker
aliasdecoding(likeHyteraswithatleastfirmwareversionv8),turnoffthissettingtolettheopenSPOT2pass
throughin-banddatatoyourradio.Ifyouhavearadiowhichdoesnotsupporttalkeraliasdecoding,turnonthis
settingtopreventissueswithdecodingvoicecallscontainingin-banddata(voicestuttering,callsdroppingetc.).
D-STARsettings
ThissectionisonlyavailableifAdvancedmodeisenabled.
IfacallisreceivedbythemodemtotheEchocallsign,thentheopenSPOT2'sbuilt-inlocalechoservicegets
activated.Itwillrecordthecallandplaysitbackafterthecallisfinished.
Settingspage
50