SharkRF openSPOT2 - NTP Settings; Wireless Settings

TheHostnameisusedbyopenSPOT2'sbuilt-inLLMNRandMDNSserverwhichmeansyou'llbeabletoopenthe
webinterfacebyenteringhttp://hostname/orhttp://hostname.local/intothebrowser.Thehostnameisalso
displayedatthetoprightcornerofthewebinterface.IfyouhavemultipleopenSPOT2sonthesamenetwork,
makesureyouusedifferenthostnamesforeachofthem.
ThefollowingsettingsareonlyavailableifAdvancedmodeisenabled.
PleaseseetheAboutthedejitterqueuesectionoftheusermanualformoreinformationontheDejitterqueue
lengthsetting.
TheopenSPOT2checksforinternetconnectionavailabilityandqualityperiodically.Theintervalofthesechecksis
setbytheInternetconn.checkintervalsetting.
TheopenSPOT2cansendit'slogtoasyslogserversetbytheSyslogserverfield.ChecktheSendlogtosyslog
servercheckboxtoenableusingthesyslogserver.
PleaseseethePowersavingsectionoftheusermanualformoreinformationaboutthePowersavingfeature.
NTPsettings
ThissectionisonlyavailableifAdvancedmodeisenabled.
TheopenSPOT2synchronizesdateandtimeusingtheNetworkTimeProtocol(NTP).Bydefault,theNTPserver
advertisedbytheWi-Finetwork'sDHCPserverisusedforsynchronizing,butiftheDHCPserverdoesnot
advertiseanNTPserver,thehostsetattheNTPserversettingwillbeused.
Note:ThewebinterfaceloadsthetimefromtheopenSPOT2onlywhenthewebinterfaceisopened.Afterthat,
thebrowserisupdatingthedisplayedclockandifthebrowser,orthewebinterface'sbrowsertabissenttothe
backgroundthenthetimewillbeupdatedmoreirregularlyduetothebrowser'sCPUpowersavingmechanism.
ThiscausesthedisplayedopenSPOT2devicetimetobeincorrect,butthisdoesnotaffecttheopenSPOT2's
clock,itwillstaycorrect.Reloadthewebinterfacetomakethedisplayedtimeaccurateagain.
Wirelesssettings
Networkpage
57