EasyManua.ls Logo

SharkRF openSPOT2 - About the Dejitter Queue

SharkRF openSPOT2
113 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
TheRSSIgraphshowsreceivesignalstrengthfromthemodem.TheBERgraphshowsreceivedBitErrorRatio
duringacall.BERiscalculatedalsoforpacketsreceivedfromthenetwork,notjustfromthemodem.The
dejitterqueuegraph(onlyshownifAdvancedmodeisenabled)showsthenumberofpacketswaitinginthe
dejitterqueue.
Aboutthedejitterqueue
Allpacketsreceivedfromthenetworkwillfirstgotothisqueuetoeliminatenetworkjitter.
Ifthedejitterqueuelengthistooshort,thegraph'slinecantouchzeroduringacallandtheaudiocanstopfor
amomentasthemodemrunsoutofframestotransmit.
Ifthequeue'slengthistoolong,thedelaycanbeuncomfortablyhigh.
Youcanusethisgraphtosetaproperdejitterqueuelength.Thereshouldbeatleastafewpacketsinthe
dejitterqueuewhenreceivingacallfromthenetwork.YoucansetthedejitterqueuelengthontheNetwork
page(thesettingonlyshowsupifAdvancedmodeisenabled).Asageneralrule,ifyouhaveagoodnetwork
connectiontotheselectedconnector'sserver,setdejitterqueuelengthto500ms,andifyouhavea3G/4G
internetconnectionorvoicestuttersalot,trysettingthelengthtoatleast1000ms.
Statuspage
41

Related product manuals