SharkRF openSPOT2 - Page 30

openSPOT2isconnectedtotheWi-Finetworkandaspecialconnectorisactive(ex.Nullconnectoror
AutoCal):
openSPOT2isconnectedtotheselectedserverandisstandingby:
openSPOT2isconnectedtotheselectedserverandisinpowersavemode:
openSPOT2isconnectedtotheWi-Finetwork,butthere'saproblemwiththeinternetconnection:
TheLEDwillshowthisstateiftheopenSPOT2isconnectedtoaWi-Finetwork,tryingtoconnecttothe
selectedserver,butitcan'tbecausethere'saproblemwiththeinternetconnection.Thiserrorcanbecaused
iftherouter,network,ortheinternetserviceproviderisusingaproxyorsomekindoftrafficfilteringwhich
blockstheopenSPOT2fromconnecting.
UpgradingWi-Fimodulefirmware:
TheLEDmayshowthisstatefor1-2minutesafterasuccessfulfirmwareupgrade,ifthere'sanewWi-Fi
modulefirmwareisavailableandbeingflashedtotheopenSPOT2'sWi-Fimodule.DoNOTunplugthe
openSPOT2duringtheupgrade!
Modemtransmitting:
LEDstates
30