EasyManua.ls Logo

SharkRF openSPOT2 - Page 96

SharkRF openSPOT2
113 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
UsinganNXDNconnectorwithaC4FMradio
Afteryou'veactivatedtheNXDNconnector,switchthemodemtoC4FMmode(orC4FMHalfDeviationmode,if
yourradioneedsthat).OnlycallsinDN(DigitalNarrow)modewillbeconverted,ifyoutransmitinothermodes,
NXDNuserswillonlyhearsilence.
AllC4FMcallswillbesenttotheDefaultcrossmodedestinationIDontheNXDNnetwork.
ThesourceNXDNIDofyourcallsfromtheC4FMradiowillbesettotheIDassociatedwiththesourcecallsign.If
there'snoIDassociated,thenthesourcecallsignwillbeparsedintoanumberandthiswillbeusedasthesource
NXDNID.Ifitcan'tbeparsedintoanumber,thenthe[DefaultcrossmodesourceID]willbeused.ThedefaultID
willbeusediftheAlwaysusethisIDincrossmodesettingisenabledfortheDefaultcrossmodesourceIDon
theSettingspage,NXDNsettingssection.
ThecallsignofincomingNXDNcallswillbesettothecallsignassociatedwiththeNXDNID.Ifthere'snocallsign
associatedinthedatabase,thentheDefaultcallsignforcrossmodecallswillbeused.Ifit'snotset,thecallsign
willbethesourceNXDNIDastext.
UsingaP25connectorwithaC4FMradio
Afteryou'veactivatedtheP25connector,switchthemodemtoC4FMmode(orC4FMHalfDeviationmode,if
yourradioneedsthat).OnlycallsinVW(VoiceWide)modewillbeconverted,ifyoutransmitinothermodes,
P25userswillonlyhearsilence.
ThesourceP25IDofyourcallsfromtheC4FMradiowillbesettotheIDassociatedwiththesourcecallsign.If
there'snoIDassociated,thenthesourcecallsignwillbeparsedintoanumberandthiswillbeusedasthesource
P25ID.Ifitcan'tbeparsedintoanumber,thentheDefaultcrossmodesourceP25IDwillbeused.Youcanset
thistoyourDMR/P25/CCS7ID.
ThecallsignofincomingP25callswillbesettothecallsignassociatedwiththeP25ID.Ifthere'snocallsign
associatedinthedatabase,thentheDefaultcallsignforcrossmodecallswillbeused.Ifit'snotset,thecallsign
willbethesourceP25IDastext.
Crossmodemmodes
96

Related product manuals