Sharp ER-A280F - Stacked Report

142
■ Stacked report
Your register is equipped with the stacked report printing function that enables multiple X/Z reports to be
printed in sequence with a single request.
You can select a maximum of twenty reports from the stacked
reports list. Some reports can be set their parameters such as
“START CODE” and “END CODE.”
• 01 GENERAL
General report
• 02 DEPT./GROUP (Use the numeric entry)
Full department report
Parameter: Starting department code/ending department
code (1 through 99)
• 03 GROUP TOTAL
Full group total report on departments
• 04 PLU/EAN (Use the numeric entry)
PLU report by designated range
Parameter: Starting PLU code/ending PLU code
(1 through 999999)
• 05 PLU/EAN STOCK (Use the numeric entry)
PLU stock report
Parameter: Starting PLU code/ending PLU code
(1 through 999999)
• 06 PLU/EAN 0 SALES (Use the selective/numeric entry)
PLU zero sales report
Parameter: 1 ALL/2 BY DEPT.
When “2 BY DEPT.” is selected, enter a department code (1
through 99).
• 07 PLU CATEGORY (Use the numeric entry)
PLU/EAN by price category
Parameter: Starting price/ending price
• 08 TRANSACTION
Transaction report
• 09 TL-ID
Total in drawer report
• 10 COMMISSION
Commission sales report
• 11 ALL CLERK
Full clerk report
• 12 ALL CASHIER
Full cashier report
Procedure
▼
▼
▼
Select a stacked report no. from
the stacked reports list.
When you are allowed to set the
parameter of a report, the following
window will appear.
ER-A280F_N(SEEG)(E)-7 09.6.18 6:55 AM Page 142