175
Installing and Removing the Paper Roll
■ Recording paper specifications
Be sure to use paper rolls specified by SHARP.
The use of any other paper rolls than specified could cause paper jamming, resulting in register malfunction.
Paper specification
Paper width: 57.5 ± 0.5 mm
Max. outside diameter: 80 mm
Quality: Thermal paper
Paper tube: 18 mm
• Be sure to set a paper roll prior to using your machine, otherwise it may cause a malfunction.
Install the paper roll in the printer. Be careful then to set the roll and cut the paper end correctly.
If the top end of the paper roll is fixed with paste or tape, the paper may lose its color
development ability in the pasted or taped area due to the deterioration of the heat-sensitive
color development component of the paper surface. This may result in nothing appearing at this
location when printing is performed. Therefore, when setting a new paper roll in the machine, be
sure to cut off approximately one revolution (approx. 25 cm long).
(How to set the paper roll) (How to cut the paper end)
■ Installing the receipt paper roll
Precaution: The paper cutter is mounted on the printer cover. Be careful not to cut yourself.
1. Remove the printer cover.
2. Push down the print roller release lever to open the print
roller arm.
Correct Incorrect
To the printer
Incorrect
To the printe
Correct
NOTE
ER-A280F_N(SEEG)(E)-9 09.6.18 6:56 AM Page 175
To Next Page
Loading...
Need help?
General
Weight and Dimensions
