Sharp ER-A280F User Manual

181
Installing the Fixing Angle Bracket
To prevent the register from moving when the drawer opens, the fixing angle bracket is supplied with the
register. By attaching the bracket to the table where the register is installed, you can hock the register on
this bracket and secure the register to its position.
How to install the fixing angle bracket
1. Thoroughly clean the location where the fixing angle
bracket (B) is to be placed.
2. Peel off the adhesive tape on the fixing angle bracket.
3. Hook the angle bracket onto the hook (A) that is located
at the bottom rear of the register.
4. Firmly stick the fixing angle bracket to the table surface
that your cleaned above.
How to remove the register from the fixing angle bracket
1. Lift up the front of the register and pull the register
towards you.
ER-A280F_N(SEEG)(E)-9 09.6.18 6:56 AM Page 181

Sharp ER-A280F Specifications

General

Types of payment	Cash
Keyboard number of keys	70
Supported paper width	58 mm
RS-232 ports	4
Operating temperature (T-T)	0 - 40 °C

Weight and Dimensions

Depth	365 mm
Width	330 mm
Height	225 mm
Weight	9000 g