Appendix
98
Q Be sure to tightly seal the plastic bag
containing the camcorder.
W Remove the bag when the air temperature
inside it reaches the temperature of the
room.
• “Dew” warning feature
If dew forms, the word “DEW” flashes on the
screen, and the power will automatically turn
off in approximately 10 seconds.
Q If “DEW” flashes, remove the cassette, leave
the cassette compartment open, and wait
for a few hours to allow the camcorder to
acclimatise to the surrounding temperature.
W To use the camcorder again, turn on the
power after waiting for a few hours. Be sure
that “DEW” has disappeared.
E Do not insert a cassette while “DEW” is
flashing; this may result in damage to the
tape.
R Since dew forms gradually, it may take 10 to
15 minutes before the dew warning feature
engages.
Plastic bag
AC Adapter/Battery Charger
• The AC adapter/battery charger may interfere
with reception if used near a radio.
• Prevent flammables, liquids, and metal
objects from entering the adapter/charger.
• The adapter/charger is a sealed unit. Do not
attempt to open or modify it.
• Do not damage, drop, or subject the adapter/
charger to vibration.
• Do not leave the adapter/charger in direct
sunlight.
• Avoid using the adapter/charger in humid or
extremely hot places.
Dew Formation
• What is “dew formation”?
When cold water is poured into a glass, dew
drops form on the glass. This clinging of
water drops is called dew formation.
• When dew forms in your camcorder.
Dew will gradually form on the head drum of
your camcorder and make the video tape
stick to the head. This causes damage both
to the head and the tape. When dew
formation occurs, recording and playback
may not function properly.
Dew is likely to form in the following circum-
stances:
—When moving the camcorder from a cold
place to a warm place.
—When placing the camcorder in a cold
room which is then heated rapidly.
—When moving the camcorder outdoors from
an air conditioned room.
—When placing the camcorder in the direct
path of air blowing from
an air conditioner.
—When placing the
camcorder in a humid
room.
Replacing the Fluorescent Lamp
This camcorder uses a fluorescent lamp to
backlight the LCD monitor. If the monitor
becomes dark or difficult to view, the fluo-
rescent lamp may need to be replaced.
Contact the nearest SHARP service centre or
your dealer for further advice.
• How to prevent trouble due to dew
formation.
When using the camcorder in a place where
dew formation is likely to occur, allow the
camcorder and the video tape to acclimatise
to the surroundings for about one hour.
For example, when bringing the camcorder
indoors after skiing, place it in a plastic bag.
VL-PD6H/093-103 01.4.24, 0:45 PM98
Downloaded from: http://www.usersmanualguide.com/
To Next Page
Loading...
Need help?
General
