Advanced Features
Playback
Advanced
Features
65
POWER
TV/VCR SET UP
CHANNEL
REC
PLAY
STOP/
EJECT
PAUSE
/STILL
A
/
V
+
S
A
/
V
+
S
Editing
Video editing lets you refine your videos by
removing unwanted sequences from your tape,
or transposing one sequence with another.
This camcorder lets you monitor the source
programme on the built-in LCD monitor without
having to connect it to an external TV or video
monitor.
Connect the camcorder to a VCR with the sup-
plied audio/video/S-video cable, as shown.
Cutting Unwanted Sequences
1 Play back the tape to be edited on the
camcorder, and locate the beginning
and end of the sequence you wish to
cut. Write down the time code or tape
counter readings at the beginning and
end of that sequence (see pages 45 and
46). Then, rewind the tape to before the
beginning of the portion that you wish to
keep.
2 Load a video cassette into the recording
VCR.
3 Press the Play/Still button (
) on the
camcorder to begin playback, and then
press the REC (Record) button on the
VCR to begin recording.
4 Press the Pause/Still button on the VCR
to pause recording when the source
tape reaches the beginning of the
sequence to be cut.
5 Press the Pause/Still (or REC) button on
the VCR to resume recording when the
source tape reaches the end of the
sequence to be cut.
To stop editing
Press the Stop buttons on the camcorder and
the VCR.
Notes:
• Some of the transitions between edited
sequences may be slightly off.
• There may be picture noise during video search
or still playback. This does not imply a defect in
the camcorder.
• The time code display will be recorded along
with the edited sequences if the OUTPUT item is
set to “ON”. Set to “OFF” before editing (see
page 45).
• The camcorder can only be used as a signal
source, it cannot be used for recording external
video or audio signals (analogue or digital).
Recording
Yellow: To video input jack
White: To audio input (L) jack
Red: To audio input (R) jack
To S-video
terminal
Audio/video/S-video
cable (supplied)
Playback
Notes:
• If your VCR has a 21-pin Euro-SCART connector,
use the RCA/21-pin Euro-SCART conversion
connector (QSOCZ0033TAZZ) available from our
main parts distributor detailed on page 101.
A/V+S terminal
To A/V+S terminal
0
VIDEO AUDIO
(L/MONO)
AUDIO
(R)
21-pin Euro-SCART on VCR
Audio R
Audio L
Video
• If your VCR has only one audio input jack, use
the white plug for the audio connection on the
VCR.
• If your VCR has an S-video input terminal, you
can use the S-video plug of the supplied audio/
video/S-video cable for the video connection on
the VCR. (The yellow video plug does not need
to be connected to the VCR.)
RCA/21-pin Euro-SCART
conversion connector
(QSOCZ0033TAZZ)
VL-PD6H/060-069 01.4.24, 0:19 PM65
Downloaded from: http://www.usersmanualguide.com/
To Next Page
Loading...
Need help?
General
