Preparation
Preparation
17
Using the Viewfinder
You can record the subject through the
electronic LCD colour viewfinder. You can also
watch video playback through the viewfinder.
1 Place your finger in the indented section
and pull out the viewfinder horizontally.
Note: You can raise the viewfinder to better
aim the camcorder depending on the
position you are in.
2 Hold down the Lock
button and set the
Power switch to
CAMERA or VCR.
• A picture is displayed in
the viewfinder.
Closing the viewfinder
Lower the viewfinder (Q), and push it in
completely (W).
Cautions:
• Do not use excessive force when moving
the
viewfinder.
• Do not pick up the camcorder by the viewfinder.
Notes:
• The viewfinder automatically turns off when the
LCD monitor is opened. When the vertical
rotation of the monitor is between 135° and 180°,
however, the viewfinder is on and the subject is
displayed both in the viewfinder and on the
monitor (see page 43).
• Be sure to close the viewfinder after use.
Adjusting the Dioptre
Adjust the dioptre according to your eyesight
when the picture in the viewfinder is not clear.
1 Pull out the viewfinder horizontally with
your finger, and then lift it up.
2 Hold down the Lock button and set the
Power switch to CAMERA.
3 While looking through the viewfinder,
turn the Dioptre adjustment dial until the
indicators in the viewfinder are clearly
visible.
Viewfinder
Power switch
Lock button
Dioptre
adjustment dial
VL-PD6H/009-018 01.4.24, 0:25 PM17
Downloaded from: http://www.usersmanualguide.com/