Useful
Features
46
Using the Tape Counter
The tape counter shows the elapsed playback
or recording time in hours, minutes and
seconds during tape playback or tape
recording. (The counter continues to count
internally even while it is not being displayed.)
This feature can be set and used in both Tape
Playback and Tape Recording modes.
• The example screens for this feature are for Tape
Playback mode.
1 Before tape playback (or tape record-
ing), press the MENU/DISPLAY button
until the menu screen appears.
2 Turn the SET-PUSH dial (Q) to select
“TIME CODE”, and then press the dial
(W) to display the time code screen.
4 Turn the SET-PUSH dial (Q) to select
“RESET”, and then press the dial (W).
• The time code display changes to the
tape counter display, which is set to
“0:00:00”.
Time code
MEMORY
TIME CODE
RESET
DISPLAY
OUTPUT
TC0 05 35
END
[
MENU/DISPLAY
]
ON
OFF
PUSH
REMOTE
T I ME CODE
DISPLAY
SOUND
END
[
MENU/DISPLAY
]
OFF
-----------
3
----------
-----------
4
----------
ON
M
ENU
CH IME
Q
W
PUSH
MEMORY
TIME CODE
RESET
DISPLAY
OUTPUT
OFF
OFF
MEMORY
TIME CODE
DISPLAY
OUTPUT
00000
END
[
MENU/DISPLAY
]
ON
OFF
RESET
Q
W
Tape counter
SP
AUDIO
1
+
2
60
min
00002
3 Press the SET-PUSH dial to set the
DISPLAY item to “ON”.
• The time code appears.
Note:
• The counter reading may differ slightly from the
actual time. This is especially noticeable when
the tape has been rewound or fast forwarded a
number of times, in which case there can be a
difference of several seconds.
To turn off the tape counter
After performing step 2 above, turn the SET-
PUSH dial to select “DISPLAY”, and then press
the dial to select “OFF”.
5 Press the MENU/DISPLAY button to
turn off the time code screen, and then
begin tape playback (or tape recording).
• You can check the playback (or record-
ing) time with the tape counter.
VL-PD6H/044-047 01.4.24, 0:20 PM46
Downloaded from: http://www.usersmanualguide.com/
To Next Page
Loading...
