7
© 2012 SHFL entertainment, Inc.
MD2® CR
Service Manual 20121015
Confidential
The shuffler will default to the last setup prior to power down. A typical
message panel display might read:
If no change is required, pushing the GREEN button will raise the Feeder
Elevator. A message will be displayed for loading:
The number of cards is based on the number of decks entered previously.
Load the correct number of cards and push the GREEN button again. The
Feeder Elevator moves down and the shuffle starts.
When the shuffle is complete, the GREEN button lights up. Push the
GREEN button and the Feeder Elevator comes up. Load the second deck
and push the GREEN button again. The shuffled deck will be raised and
the un-shuffled deck lowered. Remove the shuffled deck from the
Platform and proceed with the game. The Platform will automatically go
down and the shuffle will start.
If a change is required, push the RED button after power up. Change the
game and number of decks with the RED button. Select the game and
number of decks with the GREEN button.
Count Mismatch
If Card Recognition is set ON (see Section 4.0), including an extra card in
the deck results in an error message. The (M)issing, (U)nknown or e(X)tra
card is identified. This is a typical display:
Turn power ‘OFF’ to the shuffler. Turn power ‘ON’ again and remove the
deck. Find and remove the extra card and look for additional invalid cards
(such as Jokers or company logo cards) before restarting the shuffling
procedure.
Spanish 21 8 Deck
Green: Select Red:Change
BJ/War/Bac 8 Deck
Green:Select Red:Change
Load 416 Cards
Push GREEN button
417 Cards M: 0 U: 0
X: 2D Push RED Button
To Next Page
Loading...
