SHFL MD2 CR - 12.0 F1174 Camera Focusing Instructions; Additional Equipment Required; Focusing Instructions

76
© 2012 SHFL entertainment, Inc. MD2® CR Service Manual 20121015
Confidential
12.0 F1174 Camera Focusing Instructions
The Focusing Fixture Assembly, Part Number F1174, provides a means to
accurately focus the camera for the MD2® CR shuffler prior to installing,
or re-installing the camera into the shuffler body.
This document provides instructions for use of the Fixture in the field.
Additional Equipment Required
PC Monitor with VGA Cable and Power Cable
P2081 Yellow Torque-Seal
P2083 Lens Cleaning Cloth
Be certain that the Fixture is connected to a grounded outlet during use.
Additionally, when working with a Camera PC Board, the technician
should use a properly grounded anti-static device, such as a wrist strap.
Focusing Instructions
1. Connect a PC Monitor to the F1174 Fixture using a standard VGA
Cable.
2. Connect the Fixture (Power cord is included) and the Monitor to a main
power source.
3. Remove the Camera Bracket Assembly from the shuffler.
4. Connect the Camera Ribbon Cable from the Fixture to the Camera PC
Board.
5. Clamp the Camera Bracket Assembly into the correct position on the
F1174 Fixture. See the photos, below. Apply downward pressure on
the Assembly while clamping.
6. Remove the Camera Lens Cap, if present.
7. Turn power ‘ON’ to the Fixture and the Monitor.
8. View the live image on the Monitor. Turn the Camera Lens to focus the
camera on the calendar text. The text should appear very clear and
sharp.
9. Place a clean, white card or piece of paper on the Platform under the
camera lens. Make sure that a clear, spot-free picture is present. If
spots do appear, clean the camera lens and/or the internal CCD chip
to remove all dirt or dust.
10. When the camera is focused, apply a small amount of the P2081
Yellow Torque-Seal adhesive between the threads and the camera
housing to prevent the lens from rotating. See Figure 3.