12
© 2012 SHFL entertainment, Inc.
MD2® CR
Service Manual 20121015
Confidential
Selecting Card Type
The factory-set Card Recognition values are different for every card type.
In order for the
MD2® CR
shuffler to accurately recognize the rank and
suit, it must be set to the card type that is currently in use. The password
is not required.
The message panel will display the first card type. The card type
displayed will vary, depending upon what has been initially loaded or
what decks have been selected. This is a typical display:
Use the RED button to cycle through the pre-loaded card types. A
maximum of ten card types can be displayed and selected. There may be
many more card types recorded in the shuffler’s memory. Ten card types
are selectable from the Deck Library web page (see Section 5.0). The
design philosophy is that standard card types should be easily available,
but that a user would probably not employ more than ten deck types at
one time.
Press the GREEN button to select the card type and advance to the next
menu selection.
Set Unloading Delay
This setting adjusts the delay time in seconds before the Platform lowers
after the shuffled cards are removed from the machine. The selectable
range is 5 seconds to 20 seconds.
To change the number, press the RED button until the desired delay is
displayed.
Press the GREEN button to select and advance to the next menu selection.
Select Card Type
Bee E 1566 – Standard Index
Set Unloading Delay
15
To Next Page
Loading...
