46
© 2012 SHFL entertainment, Inc.
MD2® CR
Service Manual 20121015
Confidential
Card Tuning
Card Tuning is the second step of the card learning process. In this step,
card parameters are fine tuned. Based upon the Learned parameters, each
of the 52 or 53 cards in the deck type is read in. The card images
scanned replace any images already stored in the shuffler for that deck
type. (The card images of any library deck type are not used for
comparisons but are available to allow the technician to calibrate the
image parameters.) Camera settings are automatically adjusted and
stored.
Deck Library Tuning Procedure
1. Plug the network cable from the computer into the shuffler.
2. Enter the Setup Menu on the shuffler by cycling power while holding
down the RED button on the machine.
3. Use the GREEN button to cycle through the setup options until you see
“Enter Password”.
4. Enter the General password.
5. Continue to cycle through the options until “Select Card Type”
appears.
6. Select the card type from the menu. If the card type is not available in
the Setup menu on the shuffler, verify that the card type has been
Learned and the “Menu” box is checked on the Deck Library web page,
(Figure 5-7) and that not more than ten decks have been selected.
7. Cycle through the Setup menu options until “Tune Cards” or “Tune
Cards + Joker” is displayed.
8. Press the RED button to select the desired option.
9. Arrange the decks (with or without the Joker), as shown:
Fifty two cards, without the Joker, stacked face down, in the following
order:
To Next Page
Loading...
