1
© 2012 SHFL entertainment, Inc.
MD2® CR
Service Manual 20121015
Confidential
General Safety Guidelines
The
MD2® CR
Shuffler with Card Recognition has ventilation slots that
allow air to circulate through the shuffler to prevent overheating. These
ventilation slots must always be kept open and free of any debris or
blockage.
The shuffler is equipped with a power cord appropriate for use in North
America. If the shuffler is being utilized outside North America, please
check the requirements of that country to ensure that the power cord
meets its requirements. As a minimum, the power cord used with the
shuffler must meet the following requirements: 0.5 amps, 100-240 volts.
Be certain that the shuffler is connected to a grounded outlet when in
use. Additionally, when working on the shuffler the technician should use
a properly grounded anti-static device, such as a wrist strap.
To ensure proper operation of the shuffler, avoid any liquid spills or the
introduction of any foreign objects into the shuffler. Such an introduction
could cause fire, electrical shocks or other significant malfunctions.
When operating the shuffler, be sure all covers are properly in place and
only operate the shuffler in accordance with these operating instructions.
Do not make any adjustments to the controls on the shuffler except in
accordance with the procedures set forth in this manual. Do not turn the
shuffler on and off in rapid succession – turn it ‘ON’ or ‘OFF’ in a
deliberate manner.
To Next Page
Loading...
