18
© 2012 SHFL entertainment, Inc.
MD2® CR
Service Manual 20121015
Confidential
5.0 Shuffler Web Pages
Integrated Web Pages
The
MD2® CR
with Card Recognition is a network device with integrated
web pages; a user can connect to the shuffler and access these web
pages to change shuffler settings, add new or delete old deck types,
review card images, view card recognition errors, and perform other
configuration actions using the browser.
Card Learning is another procedure that is facilitated by using the web
pages in conjunction with displayed message panel procedures.
Connecting to the
MD2® CR
Shuffler
Although the web pages can be accessed over a network from any
browser (such as Microsoft Internet Explorer), typically the shuffler will be
connected to a laptop used for technical service. In this case, the shuffler
acts as a server and the laptop (or desktop) computer is connected,
possibly using a crossover network cable if required. The “network” here
consists of the laptop and the
MD2® CR
Shuffler. This section generally
describes how to connect the laptop to the shuffler, since there may be
some subtle differences.
MD2® CR
Shuffler and Laptop/PC Configuration
Shuffler Setup
1. Enter the Setup Menu on the shuffler by cycling power ‘ON’ while
holding down the RED button.
2. Use the GREEN button to page through the setup options until you see
“Enter Password”.
3. Enter the General password.
4. Use the GREEN button to page through the menu until ‘Network
Options’ is displayed.
5. Use the RED button to page through the network options until ‘Enable
Network Yes/No?’ appears. Verify that ‘Network Enabled’ is selected.
6. Use the GREEN button to page through the network options until
‘DHCP Yes/No?’ is displayed. Verify that ‘DHCP Disabled’ is selected.
Computer Setup
The Proxy Server on the computer must be disabled before attempting to
access the web pages. If it is not disabled, the computer cannot access
the shuffler. Follow these steps to disable the Proxy Server:
To Next Page
Loading...