Adjustment
GMS800 · Operating Instructions · 8013025 V1.2 · © SICK MAIHAK GmbH 41
Subject to change without notice
6.1.3 Internal organization of adjustment procedures
Three internal instances are decisive for adjustment:
– The Test Gas Table – to program test gas settings
– Sequence control programs for adjustment
– Long-term timer – for time-controlled automatic starts of sequence control programs
Fig. 9 Internal organization of adjustment procedures
I/O module
● Controls automatic gas
feed
Start signal
Test Gas Table
● Nominal value
● Use for adjustments
● Associated digital output
Sequence control program
● Controls gas feed
● Controls the adjustment
procedure
Analyzer module
● Adjusts based on nominal and actual values
Nominal value
Adjustment signal
Control signal
Test gases
Long-term timer
● Starts sequence
control program
automatically
Assignment
Electric control
To Next Page
Loading...
