Start-up and Parameter Settings
DUSTHUNTER T · Operating Instructions · 8012428 V 2.0 · © SICK MAIHAK GmbH Germany 85
4.6.3.2 Sender/receiver unit
The following steps are required to enter the regression coefficients:
b
Set the sender/receiver unit in maintenance mode and select the „Parameter” sub-
menu.
b
Choose the parameter to be entered and set the default password „1234“.
b
Select the calculated coefficient using the "^" and/or "→" buttons and write it to the
device with "Save"
Figure 71 Entering the regressions coefficients
To Next Page
Loading...
Need help?
General
