84 DUSTHUNTER T · Operating Instructions · 8012428 V 2.0 · © SICK MAIHAK GmbH Germany
Start-up and Parameter Settings
Bild 70 Menu structure for setting the analog output / input parameters and assigning the MCU variant
Assigning the MCU variant
The following steps are required to assign the MCU later to the existing sender/receiver
unit of the DUSTHUNTER T50, T100 or T200 (
→
p. 65, §4.4.1), :
b
Set the MCU in maintenance mode, call the „MCU Variant” submenu, and select the
type „DUSTHUNTER T”.
b
Enter the default password and store the type with „Save”(confirm 2x).
The other assigning possibilities are not practicable here.
To Next Page
Loading...
