COMMISSIONING 6
8017768/12AX/2019-05-31|SICK
Subject to change without notice
OPERATING INSTRUCTIONS | TIC
6.7.2 Displaying measurement points
In the live view, you can show the measurement points to visualize what a 2D LiDAR
sensor can see on the basis of the system parameters. This helps to localize any errors
when launching a configuration.
1. Go to the device level in the navigation tree and click the Visualize live data for device
icon. The functions for visualizing the measurement points in the live view appear.
2. Click Raw measuring points. The measurement points detected by the 2D LiDAR
sensor are displayed in the live view of TEMS Manager. The display is based on the
unfiltered raw data for the 2D LiDAR sensor’s entire visual range.
3. Click Relevant Measurement Points. The live view of TEMS Manager now shows the
filtered measurement data from the 2D LiDAR sensors. The filtered measurement
data are used as the basis for the 3D point cloud and the resulting calculations.
If you click on the expanded function again, the measurement points disappear from view.
Note
To Next Page
Loading...