SYSTEM DESCRIPTION 3
8017768/12AX/2019-05-31|SICK
Subject to change without notice
OPERATING INSTRUCTIONS | TIC
3.2 System components and scope of delivery
Thorough inspection for completeness and damage
It is recommended that you carefully check for and report transport damage of any kind
as soon as possible after receiving the system.
Also verify that the delivery includes all components listed on the delivery note.
▸
Report any incomplete or damaged deliveries to Customer Service.
▸
Always document the damage by taking photographs.
3.2.1 Components of the TIC102 system function
The TIC102 system function is designed for use in multi-lane, free-flowing traffic and stop-
and-go traffic for toll systems and for performing traffic management. It classifies vehicles
from different category systems and also detects vehicles when they switch lanes.
The TIC102 monitors exactly one lane. Up to four TIC102 units can run on the Traffic
Controller. Up to four lanes can be detected in this way.
System components
The TIC102 system function consists of the LMS Width and LMS Length system
components. These system components use LMS111 type 2D LiDAR sensors. They are
permanently installed in a housing and aligned to each other at a 25° angle.
Fig. 4: System components – TIC102
The LMS Width aligned with the side of the lane records the vehicle's profile in individual
2D profile sections. The LMS Width also detects vehicles when they change lanes.
The LMS Length (which is aligned along the lane) is responsible for vehicle tracking,
measures changes in vehicle speed, and provides the time axis to which the individual
2D cross-sections are assigned.
To Next Page
Loading...