MOUNTING 4
8017768/12AX/2019-05-31|SICK
Subject to change without notice
OPERATING INSTRUCTIONS | TIC
4.2.2 Mounting the TIC502
Risk of injury due to falling components
One TIC502 weighs approximately 12 kg.
Measures
Do not perform any mounting work alone.
Ask a second person to hold the components during mounting.
Wear safety shoes.
4.2.2.1 Noting the serial numbers of the 2D LiDAR sensors if there are several TIC502 Slaves
If the measurement site is intended to have more than one TIC502 Slave, you must note
the serial numbers of the LMS511 SE before mounting. This information is required
during commissioning when manually assigning the devices to the system functions in
TEMS Manager.
Fig. 69: Mounting TIC502 – noting serial numbers of the 2D LiDAR sensors
Note which component of the TIC502 has which serial number and mark the TIC502
accordingly so that it can be mounted at the right place.
Recommendation
To Next Page
Loading...