6 COMMISSIONING
8017768/12AX/2019-05-31|SICK
OPERATING INSTRUCTIONS | TIC
Subject to change without notice
3. Click the Start Update button. You will see a message indicating that a maintenance
process is about to be started on the TEMS Recorder.
4. Click Continue. The TEMS Recorder update is installed on the Traffic Controller. This
process may take a little while.
5. You will receive a notification once the process has finished.
6. To complete the operation, confirm the message by clicking OK.
6.10.3 Updating packages
Additional system components, plug-ins, and configuration files (e.g., Vehicle Classifier)
are supplied as separate files in the temsPackage file format. Once again, they are
installed via TEMS Manager.
The procedure is very similar to the one for TEMS Recorder updates.
The configuration that is currently running has to be stopped for this.
1. Save the temsPackage file in a directory of your choice on the customer network.
2. Go to the Setup workspace and click Update Packages.
3. Select the temsPackage file. First of all, the file is uploaded to the Traffic Controller.
After that, installation commences.
4. Install any additional temsPackage files (where applicable) using the same process
as described above.
Note
To Next Page
Loading...