6 COMMISSIONING
8017768/12AX/2019-05-31|SICK
OPERATING INSTRUCTIONS | TIC
Subject to change without notice
6.7.3 Displaying the device status
In expert mode, you can access status information on the individual system components
during operating mode.
1. Go to the toolbar above the navigation area and click the Activate/deactivate expert
mode icon.
2. Click the Show Details icon for one of the system components.
3. Open the States area to display the status information for the system component
concerned.
4. In the event of a fault, you can (for example) refer to this information to see if the
2D LiDAR sensor is affected by contamination (see also 8.3.1 Fault diagnosis in TEMS
Manager).
6.7.4 Switching back to editing mode
When in operating mode, you can return to editing mode, change settings, and restart
configuration directly at any time.
▸
Go to the toolbar above the navigation area and click the Edit site configuration icon.
You can only switch to this mode if you are logged in as a user with Authorized User
authorization or higher.
Note
To Next Page
Loading...