SYSTEM DESCRIPTION 3
8017768/12AX/2019-05-31|SICK
Subject to change without notice
OPERATING INSTRUCTIONS | TIC
3.2.3 Components of the TIC501 system function
The TIC501 system function is designed for use in multi-lane, free-flowing traffic and for
traffic management applications and simple toll systems.
The TIC501 delivers higher number and classification accuracy in flowing traffic. In stop-
and-go traffic, the classification accuracy and the detection of speed and vehicle length is
reduced.
A TIC501 can detect several lanes (1 to 3) at the same time. Up to four TIC501 units
can run on a Traffic Controller TIC. The TIC501 system function therefore supports the
monitoring of several roads.
System components
A TIC501 consists only of one LMS511 type 2D LiDAR sensor and a Traffic Controller.
Fig. 8: System components – TIC501
The customer will also require a power supply unit for the voltage supply. If several
TIC501 units are used, an Ethernet switch is required.
Scope of delivery, TIC501
LMS511 SE 2D LiDAR sensor
Traffic Controller TIC with TIC software
USB stick with TEMS analyzer, TEMS info sample client, source code
for TEMS info sample client, and operating instructions
LMS511 SE 2D LiDAR sensor
Voltage supply (20 m) connecting cable for the LMS511 SE
Ethernet cable (20 m) for connecting the 2D LiDAR sensors to the
Ethernet switch
Ethernet cable (3 m) for connecting the Ethernet switch
and the Traffic Controller
If alternative LMS511 Traffic units are already used, they can continue to be used.
Arrange the corresponding accessories with your local SICK representative.
Note
Supplementary
components
Accessories
Note
To Next Page
Loading...