MOUNTING 4
8017768/12AX/2019-05-31|SICK
Subject to change without notice
OPERATING INSTRUCTIONS | TIC
4 Mounting
4.1 General advice
Mount the 2D LiDAR sensor at the position designated in the project planning.
Observe the detailed diagrams and information contained in the appendix to these
operating instructions.
Risk of damage to devices during mounting
▸
Mount the 2D LiDAR sensors so that they are protected from dirt and damage.
▸
Ensure that the field of view of each 2D LiDAR sensor is not restricted.
▸
Make sure that the connectors can be plugged in and unplugged without any difficulty.
▸
Avoid exposing the 2D LiDAR sensors to excessive shock and vibration.
Legal provisions
▸
When mounting the system components, please observe any national and local legal
stipulations and official instructions.
Prevent the 2D LiDAR sensors from falling
▸
We recommend that you secure the components that have been mounted above the
lane so that they cannot fall down, e.g., by using a chain or rope.
Refer to the project planning notes
▸
Always observe the notes provided in chapter 3.6 Project planning.
To Next Page
Loading...