6 COMMISSIONING
8017768/12AX/2019-05-31|SICK
OPERATING INSTRUCTIONS | TIC
Subject to change without notice
Taking measurements
The example below identifies the length of the tractor. This principle is the same for all
measurements.
1. Select the appropriate perspective. In this example, it is the side view.
2. Double-click on the box. The box edges are activated.
3. Click on the edge you would like to move.
4. Move the edge along the corresponding axis for the shape to be measured. The box
dimensions (here the box length) is updated.
The dimensions of the box are always crucial. There is no specific zero point
5. Check the plausibility of the dimensions shown. In this example, the length dimensions
of the tractor.
Double-clicking on the box edge shows the box with the original (maximum) vehicle
measurements.
Deactivating measurements
▸
Click the Measure icon again. The box disappears again.
Note
Note
To Next Page
Loading...