Quick Guide
S7-300 Programmable Controller Hardware and Installation
A5E00105492-01
2-5
Changing the configuration of an existing SIMATIC S7 system
Proceed as described above if you want to change an existing system
configuration.
When retrofitting signal modules, also proceed in a configuring - mounting - wiring -
etc. sequence. In this case, however, you only have to consider information that is
relevant to the new module.
Cross-reference
Also note the description of specific module in the manual: SIMATIC S7-300 PLCs,
Module Data Reference Manual.
To Next Page
Loading...
Need help?
General
