Step by Step
156
The prealarm signals a pending alarm. If you do not
confirm this prealarm, the handset sends emergency
alarm signals to the configured location.
A prealarm is indicated with Prealarm and the relevant
alarm type on the display. The handset signals the
prealarm by means of the configured warning tone.
Either: Press any display key
[ Immediately press any display key or the volume key (+/
-) in order to confirm the prealarm. The prealarm is reset
and the pending alarm is prevented. This avoids a false
alarm being issued.
Or: Confirm triggering event
The prealarm can also be confirmed by resolving the
triggering event, i.e.:
• Move handset (Non Movement)
• Move handset less (Escape Alarm)
• Position handset upright (Man Down Alarm)
• Reinsert inadvertently removed pull cord contact
(cord)
• Confirm Time Alarm by pressing any key
Technical warning on the handset
The handset can be configured so as to allow the
following operating functions to be monitored:
• Synchronicity with DECT base station
• Charge status of battery pack
If a technical fault is detected, the handset issues a
warning signal, which can be reset like a prealarm. The
reason for the fault is shown on the display.
Note:
If a prealarm is signalled during a call, you have to
first confirm the prealarm in order to prevent the
pending alarm. You can then continue the call.
Attention:
The prealarm only persists for a short time. This
duration can be exceeded and therefore a false
alarm induced. It is more reliable to confirm the
prealarm using a display key.
To Next Page
Loading...
Need help?
General