Step by Step
158
Sending an emergency alarm signal/calling
for assistance
In monitoring mode
The handset is in monitoring mode.
Automatic alarming signal
The alarm sensors in the handset recognise operating
statuses that trigger an alarming signal.
Certain alarm types initially generate a prealarm
(configurable). If you do not acknowledge this alarm, the
handset sends emergency alarm signals to the
configured alarm destination.
Manual alerting
Press the red alarm key on the handset. The handset
sends emergency alarm signals to the configured alarm
destination.
An existing call is automatically terminated. The
handset repeatedly sends emergency alarm signals
(maximum number of retries is configurable).
The necessary assistance measures are initiated by the
location that received the emergency call following the
alarming signal.
In alarm status
The handset has sent an emergency alarm signal and is
consequently in alarm status.
In alarm status: Reset the alarm functionality
The handset is in alarm status.
Press the display key. The handset disables the alarm
status/alarming signal and monitoring.
"PNG Off" is displayed again after every alarm call.
"PNG Off" is only displayed after five alarm calls. If "PNG
Off" is not pressed, the handset repeats the alarm calls
according to the configuration. The call duration and
ringing interval are each extended by one second.
To Next Page
Loading...
Need help?
General