Siemens MICROMASTER 440 - Page 16

Table of Contents Issue 10/06
MICROMASTER 440 Operating Instructions
16 6SE6400-5AW00-0BP0
Table 3-12 Parameters P0731 – P0733 (frequently used functions / states)........................................138
Table 3-13 BOP link .............................................................................................................................145
Table 3-14 COM link.............................................................................................................................145
Table 3-15 Minimum start intervals for various baud rates................................................................... 152
Table 3-16 Structural data....................................................................................................................153
Table 3-17 Thermal and electrical characteristics ................................................................................ 154
Table 3-18 Max. number of nodes (devices) depending on the max. data transfer rate....................... 154
Table 3-19 Task IDs (master -> drive converter)..................................................................................158
Table 3-20 Response ID (converter -> master) .................................................................................... 159
Table 3-21 Fault numbers for the response ID "Request cannot be executed"....................................160
Table 3-22 Example for direct coding via digital inputs......................................................................... 167
Table 3-23 Example for binary coding via digital inputs........................................................................168
Table 3-24 Mode of operation of the MOP ...........................................................................................171
Table 3-25 Selecting the motorized potentiometer ............................................................................... 171
Table 3-26 Correspondence between the parameters .........................................................................177
Table 3-27 Important parameters for the PID dancer roll control.......................................................... 180
Table 3-28 BICO parameters for ramp-function generator ...................................................................185
Table 3-29 Examples for settings of parameter P0810.........................................................................190
Table 3-30 Possible settings for parameters P0700 and P1000........................................................... 190
Table 3-31 Free function blocks ...........................................................................................................191
Table 3-32 FFB priority table................................................................................................................194
Table 3-33 Settings for parameter P1200............................................................................................. 213
Table 3-34 DC link undervoltage – shutdown threshold.......................................................................219
Table 3-35 Partial excerpt of monitoring functions / messages ............................................................222
Table 3-36 Thermal classes .................................................................................................................228
Table 3-37 General protection of the power components..................................................................... 232
Table 3-38 V/f characteristic (parameter P1300).................................................................................. 236
Table 3-39 Voltage boost .....................................................................................................................238
Table 3-40 Vector control versions....................................................................................................... 244
Table 4-1 Inverter conditions indicated by the LEDs on the SDP.......................................................258
Table 5-1 MICROMASTER 440 Performance Ratings....................................................................... 262
Table 5-2 Dimensions, required cooling air flow and tightening torques for power terminals ............. 264
Table 5-3 Current reduction depending on pulse frequency............................................................... 265
Table 5-4 Data for braking resistors ................................................................................................... 266
Table 5-5 MICROMASTER 440 Specifications .................................................................................. 266
Table 7-1 Permissible harmonic current emissions ............................................................................ 277
Table 7-2 General industrial application ............................................................................................. 278
Table 7-3 With filter, for industrial applications ................................................................................... 278
Table 7-4 With filter, for residential, commercial and trade applications............................................. 279
Table 7-5 Compliance Table .............................................................................................................. 280