7 Electro-magnetic compatibility Issue 10/06
MICROMASTER 440 Operating Instructions
276 6SE6400-5AW00-0BP0
7.1 Electro-magnetic compatibility
(EMC) All manufacturers / assemblers of electrical apparatus which “performs a
complete intrinsic function and is placed on the market as a single unit intended for
the end user” must comply with the EMC directive 89/336/EEC.
There are three routes for the manufacturer/assembler to demonstrate compliance:
7.1.1 Self-certification
This is a manufacturer's declaration that the European standards applicable to the
electrical environment for which the apparatus is intended have been met. Only
standards that have been officially published in the Official Journal of the European
Community can be cited in the manufacturer's declaration.
7.1.2 Technical construction file
A technical construction file can be prepared for the apparatus describing its EMC
characteristics. This file must be approved by a ‘Competent Body’ appointed by the
appropriate European government organization. This approach allows the use of
standards that are still in preparation.
7.1.3 EC type examination certificate
This approach is only applicable to radio communication transmitting apparatus. All
MICROMASTER 440 units are certified for compliance with the EMC directive.
when installed in accordance with the recommendations in Section 2.
To Next Page
Loading...
