9 Operation at Use of a PC
9.3 Configuration of the Device
237SICAM Q100, 7KG95xx, Device Manual
E50417-H1040-C522-A6, Edition 06.2019
Parameterizing the Serial Communication with Modbus RTU (Slave) or Modbus RTU Master
To change the serial communication settings, proceed as follows:
✧ In the navigation window, select the Administrative menu and click Communication serial.
The Communication serial input/output window opens.
✧ In the list box select Bus protocol.
If you select -none-, no protocol will be available. Click Send in this case.
Figure 9-68 Configure Tab, Communication Serial via Modbus RTU Input/Output Window
Figure 9-69 Configure Tab, Communication Serial via Modbus RTU Master Input/Output Window
MAN_SICAM_Q100_US.book Page 237 Wednesday, June 5, 2019 9:31 AM
To Next Page
Loading...
