Siemens SICAM Q100 7KG95 Series - Page 353

10 Operation at Use of the Display
10.4 Parameterization
353SICAM Q100, 7KG95xx, Device Manual
E50417-H1040-C522-A6, Edition 06.2019
Submenu Display Number 80.6: Communication
Figure 10-24 Submenu Display Number 80.6, Communication
80.6
Communication
87.0
IP Address
Enter
Edit
87.1
Communication
Ethernet


Enter
87.0
MAC addr.
IP addr.
Subnet
Gateway
+
Enter
87.1
Bus protocol:
- Modbus TCP
- IEC61850
87.2
Communication
Serial
EditEnter
87.2
Bus protocol:
- Modbus RTU
- Modbus Master
-None


Edit
Select parameters
acc. to following
table.
Ok
Esc
Working on
choice


Edit
Ok
Esc
Change the para -
meters acc. to
following table
Ok
Esc
+
-

87.13
Modbus TCP/
RTU gateway
Enter
87.13
Activated
Not activated
NOTE
The MAC address is shown on the display but cannot be edited.
For this purpose, a prompt is displayed which you must acknowledge with Ok.
MAN_SICAM_Q100_US.book Page 353 Wednesday, June 5, 2019 9:31 AM