Communications configuring
3-24 System- and communication configuring D7-SYS - SIMADYN D
Edition 12.2003
The @CEP central blocks cyclically initialize and monitor the coupling.
The coupling is therefore not enabled at the start of cyclic operation for all
transmitters/receivers, but only after a delay of several operating cycles.
After the coupling has been enabled, the @CEP central block monitors
the coupling.
NOTE
Only communication utility process data can be configured.
• For the coupling to EP3 modules, only the channel name has to be
specified at the AT- and AR I/O of the transmit/receive blocks.
Address stages 1 and 2 do not have to be configured.
• For channel names, the EP3 modules only evaluate the 5th and 6th
character of the channel name. All other characters can be selected
as required.
Configuring
To Next Page
Loading...
Need help?
General
