Communications configuring
System- and communication configuring D7-SYS - SIMADYN D 3-227
Edition 12.2003
In HW Config, the "Communications" plug-in module type must be
activated for the properties of the EXM 448.
• CBP2 communications module (COMBOARD)
3.19.2.4 Functional scope
You must configure the following function blocks when parameterizing
with “DRIVE Monitor“:
• Central block @FMPAR
− monitors the COMBOARD
− processes the parameter tasks
• Function block CBCONF
− used to configure a COMBOARD
− used to display the diagnostic data of a COMBOARD
To Next Page
