SIMATIC IPC627E
Operating Instructions, 12/2018, A5E44297201-AA
55
4.1 Switching on the device
Requirements
● The power supply is connected. (Page 47)
Procedure
1. Switch on the on/off switch on the rear of the device (position | ).
2. Press the on-off button on the rear of the device.
Information on the position of the switch and button can be found at "Front panel (Page 16)".
Commissioning the installed Windows® operating system
You can find information on first startup of the device and commissioning the installed
Windows® operating system in the documentation on the supplied data storage medium.
See also "Important instructions and manuals for operating the device (Page 11)" for more
on this.
4.2 Configuring automatic switch-on of device
In the firmware settings you can specify that the device automatically starts up again after a
separation from the mains voltage of at least 20 ms as soon as the mains voltage is
available again.
Configure this function with the firmware setting (Setup Utility > Advanced > PCH-IO
Configuration):
● State After G3
You can find information on this in the detailed firmware/BIOS description, see Important
instructions and manuals for operating the device (Page 11).
The exact minimum required downtime of the mains voltage is dependent on the device
equipment and the application.
To Next Page
Loading...
Need help?
General
