Siemens SIMATIC IPC627E

Device maintenance and repair
7.3 Removing and installing hardware
SIMATIC IPC627E
98 Operating Instructions, 12/2018, A5E44297201-AA
7.3.4 Replace power supply
Requirements
● The device is disconnected from the mains and all connecting cables have been
removed.
● The device is open, see important information regarding this under Opening the Device
(Page 71).
● An original spare part, i.e. a power supply of the same type, see notes under
Accessories: Hardware (Page 24).
Procedure - Removal
1. Remove the marked screw ①.
2. Pull the power supply connector and remove the marked screws.