EasyManuals Logo

Siemens SIMATIC IPC627E User Manual

Siemens SIMATIC IPC627E
164 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #87 background imageLoading...
Page #87 background image
Expanding and assigning parameters to the device
6.4 Drives
SIMATIC IPC627E
Operating Instructions, 12/2018, A5E44297201-AA
87
6.4.5 Replacing M.2 NVMe SSD
Note
An M.2 NVMe SSD cannot be operating in a RAID
-System.
Requirements
Note
Observe the ESD directives
Observe the ESD directives.
M.2 NVMe SSDs with an length of up to 110 mm
Phillips screwdriver P1
The drive bay module and the power supply are removed, see Replacing the bus board
(Page 100)
Procedure
1. Place the bus board on a suitable surface so that it lies flat and plane.
2. Remove the marked screw.
3. Lift the M.2 NVMe SSD slightly as shown and pull it out of the direct connector socket.
4. Lay the thermal pad on the bus board in such a manner that it is covered completely by
the M.2 NVMe SSD after the SSD's installation.

Table of Contents

Other manuals for Siemens SIMATIC IPC627E

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Siemens SIMATIC IPC627E and is the answer not in the manual?

Siemens SIMATIC IPC627E Specifications

General IconGeneral
BrandSiemens
ModelSIMATIC IPC627E
CategoryIndustrial PC
LanguageEnglish

Related product manuals